Was hoping to get your guys opinion on my new metal roof installation that I recently had done on my 1200 sqft. 47’ by 17’ on both sides single pitched bungalow roof.
I am concerned that the ridge vent might be installed incorrectly. It runs the entire length of the house on the outside but it stops 2’ or so from the end on the inside plywood cutout which i believe is fine and carries on for maybe 13’, but then the inside cutout stops for about 13’ in the middle of the house and then carries on for another 13’ more to the other end and stops 2’ or so from the end again.
Shouldn’t the cut out span the entire length of the roof ridge minus the end sections a few feet? The gap on the cutouts seem fine as they are about 2 to 3 inches or so on the inside and they have the screening installed underneath. It is just the length I am questioning. Thanks.